Connecting to your computer network - cont.
If your network allows automatic confi guration (which is normal) the radio will acquire a network address. The screen should say 'Connecting...', and then 'Setup wizard completed'. Press the Select button to exit the setup wizard
and show the main menu. You can then skip to paragraph 18 on page 17.
11,12
There are two indicator lights incorporated into the
Yellow ON = Link established; OFF = no connection
Yellow Flashing = Data transfer
Green ON = 100 Mbits/sec link; OFF = 10 Mbits/sec link | 11,12 | 11,12 |
If your network does not support automatic confi guration or if you wish to set it up manually then you should select '[Manual confi g]' instead of selecting '[Wired]' in the Network Wizard, then see page 19.
11.If you plan to use a WiFi connection, you will fi rst need to identify your network in the list of network names presented by the Network Wizard. If no networks are found then you may have to get your wireless router working (please see the instructions supplied with it) or you may be too far from the router.
When the radio fi nds your wireless network, it displays the Network Name (SSID) for the wireless access point on the screen. This is a name that is allocated to the access point in your router by the person who set up the network - for example: 'Jones family' or 'Paul's network'. If the router supports WiFi Protected Setup, then '[WPS]' will be shown in front of the SSID.
It is possible, and in some locations highly likely, that your radio will fi nd more than one wireless network, in which case you should choose which one you need to connect to.
12.Press the Menu Up or Down buttons to see the SSID for each wireless network that has been found. If your network is shown proceed to step 14 on the next page. If it is not shown then proceed to step 13.
If you make a mistake at any point, use the Back button to go back to the previous screen.
15
