107
Editing a Sample
Automatically calculating a sample’s tempo
1.
Move the cursor to “Tempo” and press [F1(CALC)].
The Tempo Calculator window appears.
2.
Use [CURSOR] to move the cursor, and use the VALUE dial
or [INC] [DEC] to specify the number of measures in the
sample and its time signature.
3.
Press [F3 (EXEC)].
The sample’s tempo will be calculated automatically.
* To cancel, press [F2 (CLOSE)].
When you want to reset the beat indication (Reset Grid function)
You can reassign the sample grid according to the specified Start
point and Tempo.
1.
In the SAMPLE EDIT screen, specify the Start point and
Tempo of the sample.
2.
Press [F5 (UTILITY)], and then press [F1 (RESET GRID)].
A message will ask you for confirmation.
3.
Press [F6 (EXEC)] to execute.
To cancel, press [F5 (CANCEL)].
Parameter Explanation
Start Refer to
Setting the Start/End Points of the Sam-
ple
(p. 106).
Loop Start
End
Loop Mode Specifies how the sample will be played.
FWD:
After the Sample played back from Start to End,
it will then be repeatedly played back in the for-
ward direction, from the Loop Start to End.
ONE-SHOT:
The sample will be played back only once, from
the Start to End.
REV:
When the sample has been played back from
End to Start, it will be repeatedly played back in
the reverse direction, from Loop Start to Start.
REV-ONE:
The sample will be played back only once from
End to Start in the reverse direction.
Tempo Original tempo of the sample
You can hold down [SHIFT] and use the VALUE
dial or [INC] [DEC] to adjust the value to the
right of the decimal point.
5.00–300.00
*In order to synchronize the tempo, Wave Temp Sync
(p. 43) must be turned ON.
Org Key Note number that will play the sample at the pitch
at which it was sampled
0 (C -)–127 (G9)
Time
Stretch
Specifies how the tempo will be synchronized.
Decreasing this value will optimize the sound
for more rapid phrases, and increasing this val-
ue will optimize the sound for slower phrases.
TYPE01–TYPE10
Start Fine Fine adjustment of the Start point
0–255
Start P.
Loop
Start P. End P.
Start P.
Loop
Start P. End P.
Start P.
Loop
Start P. End P.
Start P.
Loop
Start P. End P.
Loop Start
Fine
Fine adjustment of the Loop Start point
0–255
Loop End
Fine
Fine adjustment of the End point
0–255
Loop Tune Pitch of the loop region
Make fine adjustments in one-cent (1/100 semi-
tone) increments.
-50– +50
Zoom Horz Display magnification (horizontal axis)
1/1–1/16384
Zoom Vert Display magnification (vertical axis)
x1–x128
Parameter Explanation

About the beat

Samples contain beat data. Up to 100 beat locations are specified
for one sample. If the sample contains more than 100 beats, fifty
beat locations will be specified from the beginning and end of
the sample, respectively.
Fantom-Xa_e.book 107 ページ ２００４年１０月２２日　金曜日　午後２時３分