146
Editing Songs

Pattern Call

This is data that causes a pattern to play back. Use the Number
parameter to select the pattern number. The pattern name is shown
in parentheses ( ).
If the pattern called by the Pattern Call message extends beyond
the last measure of the song, the pattern playback will be
interrupted at that point.
*Only one pattern can be played at a time by Pattern Call messages in a
given phrase track. This means that if a Pattern Call message is
recorded at a location before the previous pattern has finished playing,
the pattern that was playing will be interrupted, and the next pattern
will begin playing. If more than one Pattern Call message is recorded
at the same location, the message that is displayed last in the
Microscope screen will be played.
* Although it is possible to record Pattern Call messages in a pattern,
they will not be played. If you want to place the data of another pattern
into a pattern, use Track Edit to copy the data.
The Tempo track records tempo data for the song.

Tempo Change

This data specifies the tempo. The song will play back according to
the “Value” of the tempo change.
The value displayed in “
= **” is the tempo at which the song will
actually play (the playback tempo), and can be changed only in the
PLAY screen of each mode.
* If the tempo change value differs from the playback tempo, this means
that the playback tempo has been changed temporarily. In other words,
since the tempo change value has not been rewritten, this setting will
be lost if you select another song or turn off the power. If you want to
play back at this tempo the next time as well, you must re-save the
song to disk. This will rewrite the tempo change value so that it
matches the playback tempo.
The Beat track records time signature data.

Beat Change

This specifies the time signature (Beat).
Since a phrase track or pattern contains a large amount of sequencer
data, the display may be cluttered and difficult to read. For this
reason, the Fantom-Xa lets you specify the type(s) of sequencer data
that will be displayed in the screen. This is convenient when you
want to check or edit only a specific type of sequencer data.
1.
Access the MICROSCOPE screen.
2.
Press [F6 (VIEW SEL)].
The View Select window appears.
fig.ViewSelect
3.
Use [CURSOR] to select the sequencer data that will be
displayed.
4.
Press [INC] or [DEC] to switch.
The message will be displayed if the check mark (
✔
) is
assigned, and will not be displayed if the check mark is
removed.
• [F4 (ALL ON)]:All of the sequencer data will be displayed
• [F5 (ALL OFF)]:None of the sequencer data will be displayed
5.
Press [F6 (CLOSE)] to close the View Select window.
Data Handled by the Tempo TrackData Handled by the Beat TrackViewing Sequencer Data (View)
Note messages System Exclusive Poly Aftertouch
Program Change Pitch Bend Channel Aftertouch
Control Change Pattern Call Tune Request
CC Select
Specifies the controller number that will be displayed.
Fantom-Xa_e.book 146 ページ ２００４年１０月２２日　金曜日　午後２時３分