82
Modifying the Sound in Real Time
You can use the D Beam controller to control the pads as an
alternative to striking the pads themselves.
1.
Hold down [SHIFT] and press D BEAM [PAD TRIGGER].
A screen like the following appears.
fig.DBeamTrig
2.
Press to select the parameter.
3.
Use the VALUE dial or [INC] [DEC] to make the setting.
4.
Press [EXIT] to return to the previous screen.
PAD trigger settings are saved independently for each
performance as part of the performance settings. This lets you
create performances that make effective use of controller
settings.
If Patch mode is selected, this is saved as part of the system
settings. If you want to save the settings, press [F6 (WRITE)].
You can assign various functions to the D Beam controller and apply
a wide range of effects to the sound in real time.
1.
Hold down [SHIFT] and press D BEAM [ASSIGNABLE].
A screen like the following appears.
fig.DBeamAsgn
2.
Press to select the parameter.
3.
Use the VALUE dial or [INC] [DEC] to make the setting.
4.
Press [EXIT] to return to the previous screen.
The settings for the ASSIGNABLE are saved independently for
each performance as part of the performance settings. This lets
you create performances that make effective use of controller
settings.
If Patch mode is selected, this is saved as part of the system
settings. If you want to save the settings, press [F6 (WRITE)].
Pad Trigger
Parameter Value Explanation
Pad Number 1–9 Pad number affected by the D Beam
Pad Velocity 1–127 Strength of the pad sound played by the D Beam controller
Pad Control Mode MOMENTARY,
LATCH
Specifies how the D Beam will behave when it is obstructed.
MOMENTARY:
The parameter will be on only while the D Beam is obstructed, and will turn off
when you stop obstructing it.
LATCH:
The parameter will alternately be switched on/off each time you obstruct the D Beam.
Assignable
Parameter Value Explanation
Type CC01–31, 33–95,
BEND UP,
BEND DOWN,
START/STOP,
TAP TEMPO,
ARP GRID,
ARP DURATION,
ARP MOTIF,
ARP OCTAVE UP,
ARP OCTAVE DOWN
Function controlled by the D Beam controller
CC01–31, 33–95:
Controller numbers 1–31, 33–95
BEND UP:
Controls the pitch as specified by the “Pitch Bend Range Up” setting (p. 41).
BEND DOWN:
Controls the pitch as specified by the “Pitch Bend Range Down” setting (p. 41).
START/STOP:
Starts/Stops the sequencer.
TAP TEMPO:
Tap tempo (a tempo specified by the interval at which you move your hand over the
D Beam controller).
ARP GRID:
Arpeggio Grid
ARP DURATION:
Duration of each arpeggiated note
ARP MOTIF:
Arpeggio Motif
ARP OCTAVE UP:
The range in which the arpeggio is sounded will rise in steps of an octave (max-
imum 3 octaves).
ARP OCTAVE DOWN:
The range in which the arpeggio is sounded will lower in steps of an octave
(maximum 3 octaves).
Range Min 0–127 Lower limit of the range of the D Beam controller
Range Max 0–127 Upper limit of the range of the D Beam controller.
By setting Range Max below Range Min you can invert the range of change.
Fantom-Xa_e.book 82ページ ２００４年１０月２２日　金曜日　午後２時３分