58
Creating a Rhythm Set

[F1 (GENERAL)]

[F2 (CTRL)]

[F3 (RX)]

Functions of Rhythm Set Parameters

Parameter Group [F1 (COMMON)]

Settings Common to the Entire Rhythm Set

Parameter Value Description

Rhythm Level 0–127 Volume of the rhythm set
Rhythm Tone
Name
You can assign a name of up to 12 characters to the rhythm tone.
Press to move the cursor, and use the VALUE dial or [INC] [DEC] to select characters.

Parameter Value Explanation

Assign Type MULTI, SIN-
GLE
Sets the way sounds are played when the same key is pressed a number of times.
MULTI:
Layer the sound of the same keys. Even with continuous sounds where the sound plays for an
extended time, such as with crash cymbals, the sounds are layered, without previously played sounds
being eliminated.
SINGLE:
Only one sound can be played at a time when the same key is pressed. With continuous
sounds where the sound plays for an extended time, the previous sound is stopped when the following
sound is played.
Mute Group OFF, 1–31 On an actual acoustic drum set, an open hi-hat and a closed hi-hat sound can never occur simultaneously.
To reproduce the reality of this situation, you can set up a Mute Group.
The Mute Group function allows you to designate two or more rhythm tones that are not allowed to
sound simultaneously. Up to 31 Mute Groups can be used. rhythm tones that are not belong to any such
group should be set to “OFF.”
Tone Env Mode NO-SUS,
SUSTAIN
When a loop waveform (p. 57) is selected, the sound will normally continue as long as the key is pressed.
If you want the sound to decay naturally even if the key remains pressed, set this to “NO-SUS.”
* If a one-shot type wave (p. 57) is selected, it will not sustain even if this parameter is set to “SUSTAIN.”

Tone Pitch Bend
Range
0–48 Amount of pitch change in semitones (4 octaves) that will occur when the Pitch Bend Lever is moved
The amount of change when the lever is tilted is set to the same value for both left and right sides.
One Shot Mode OFF, ON

ON:

The sound will play back until the end of the waveform (or the end of the envelope, whichever comes
first).
If you have set Wave Group (p. 59) to SAMP, the loop setting will be forced to ONE SHOT.
Aftertouch Time
Ctrl Sens
-63– +63 If Wave Group is set to SAMP and Wave Tempo Sync is ON, aftertouch will control the amount of time
stretching/shrinking caused by Time Stretch.
If Time Stretch is not being applied, nothing will happen. If set to “+” the stretch/shrink time will be-
come shorter, and if set to “-” the time will become longer.

Parameter Value Explanation

Tone Receive
Expression
OFF, ON For each rhythm tone, specify whether MIDI Expression messages will be received (ON), or not (OFF).
Tone Receive
Hold-1
OFF, ON For each rhythm tone, specify whether MIDI Hold-1 messages will be received (ON), or not (OFF).
* If “NO-SUS” is selected for Env Mode parameter, this setting will have no effect.

Tone Receive
Pan Mode
CONTINUOUS,
KEY-ON
For each rhythm tone, specify how pan messages will be received.
CONTINUOUS:
Whenever Pan messages are received, the stereo position of the tone will be changed.
KEY-ON:
The pan of the tone will be changed only when the next note is played. If a pan message is
received while a note is sounding, the panning will not change until the next key is pressed.
* The channels cannot be set so as not to receive Pan messages.
Fantom-Xa_e.book 58ページ ２００４年１０月２２日　金曜日　午後２時３分