Roland RD-300SX Settings for Each Function EDIT, Parameters That Can Be Set, How to Make Settings

Settings for Each Function ([EDIT])

The process of changing tone parameters to create the tones you like, and changing the settings for various functions is known as “editing.”

When [EDIT] is pressed and the indicator is lit, the RD-300SX switches to “Edit mode.”

You can save edited settings to Setups.

Edited settings are discarded when the RD-300SX’s power is turned off, so be sure that any settings you want to keep are saved to a Setup. For details, refer to “Storing Settings to Setups ([WRITE])” (p. 35). However, you cannot save System content to the Setups. If you want to save changes made to the system, perform the Write procedure separately (p. 37).

Parameters That Can Be Set

You can set the following parameters in Edit mode.

System: Settings related to the functioning of the entire instrument (p. 37)

Master Tune

Temperament, Key

Stretch Tune

Damper Pedal Polarity

Control Pedal Polarity

Setup Control Channel

Setup Pedal Shift

USB Driver

Common: Settings for pedal functions and other such functions (p. 40)

MFX Zone

Control Pedal Function

Tone: Tone settings (p. 41)

Cutoff

Resonance

Attack Time

Decay Time

Release Time

Reverb Send Level

Fine Tune

Bend Range

Upper, Lower Zone: Zone settings (p. 42)

Key Transpose

Pan

Damper Pedal Switch

Control Pedal Switch

Bender Switch

Modulation Switch

Part: Part On/Off (p. 43)

1–16

Utility: Settings for backing up, Factory Reset, etc. (p. 44)

Bulk Dump Temporary

Bulk Dump Setup

Factory Reset

TX Mode

Local Control

*Some tones are set so no effects are applied.

Making System Settings (System)

Functions that affect the RD-300SX’s overall operating environment

are called “System functions.”

How to Make Settings

1.Press [EDIT].

The indicator lights, and the RD-300SX switches to Edit mode.

2.Press [INC] or [DEC] to select “System,” then press

[ENTER].

fig.disp.SYS

3.Referring to the following, press the TONE SELECT button to which the parameter you want to change is assigned.

The parameter name appears in the display while the button is held down. When the button is released, the value for the parameter is shown in the display.

TONE	Indication	Parameter
SELECT
button
PIANO		Master Tune (p. 38)
E.PIANO		Temperament, Key (p. 38)
ORGAN		Stretch Tune (p. 38)
STRINGS/		Damper Pedal Polarity (p. 38)
PAD
GUITAR/		Control Pedal Polarity (p. 39)
BASS
BRASS/		Setup Control Channel (p. 39)
WINDS
VOICE/		Setup Pedal Shift (p. 39)
SYNTH
RHY/GM2		USB Driver (p. 39)

4.Press [INC] or [DEC] to set the value.

5.If you want to save the setting, press [WRITE]. Then, press [ENTER].

You can return to Step 2 by pressing [EXIT].

Unless they have been saved, these settings are lost when the power is turned off.

37