INSTALLER
MAKING CONNECTIONS
Speaker Connections
The speakers are connected to the CAM6.6 using modular snap connectors. Each of these
1. Pull the speaker wire conductors apart so they’re separated for the first two inches from their ends.
2. Using a wire stripper, remove 1/4 inch of insulation from each conductor. Twist the strands in each conductor into tight spirals.
3. Remove the modular
WHITE
Lift the black lever for each connection until it locks open and insert the proper speaker wire, matching channel and polarity for all four wires. Snap the lever down. Insert the modular connector into its designated output on the back of the CAM6.6.
4. Complete the same steps for the remaining zones. Label each set of speaker wires with the zone and location.
CAM6.6
32