|
| INSTALLER |
|
| INSTALLATION MENU |
| i. MACRO - | Macro loads a series of commands which are processed when |
| (Macro) | activated. |
| ii. MACRO ID – | Enter the macro ID number. Menu advances to SAVE CHANGES |
| (MacID) | (step 9) |
| e. All Other Selections: | Procedure advances to DEVICE CODE (step 7) |
7. | DEVICE CODE – | Enter source component code number listed in this manual’s |
| (DevCd) | Reference section. |
8. | KEY FUNCTION – | Select a function for the button. |
| (KeyFn) |
|
9. | SAVE CHANGES? – | Select “yes” to save changes. Procedure advances to ZONE NUM |
| (Save?) | (step 1) |
SOURCE NAMES (SrcNm)
This procedure allows the installer to customize the source names for the sources attached to the CAM6.6. See Source Names/Vol Trim - Flow Chart on page 67
1. SOURCE NUM –Select the source number this name will be assigned to. (Src #)
2. SOURCE NAME – | Select the name. SOURCE NUM will reappear on the LCD panel; |
(Name) | repeat the instructions for each source to be labeled. |
SRC VOL TRIM (SrcVT)
This procedure allows the installer to adjust the output level of an individual source. The output vol- ume is adjustable by 16dB. At 0dB
Flow Chart on page 67
1. SOURCE NUM –Select the source number this level will be set for. (Src #)
2. TRIM LEVEL – | 0dB is max output volume, |
(Trim) |
|
NUMERIC IR (NumIR)
Numeric IR allows the installer to program source specific number functions (Channel 12, Disk 89, etc.).
See Numeric IR - Flow Chart on page 68
53