Russound CAV6.6-S2 instruction manual Integrate Multiple CAV6.6’s, Rnet Link In and Link Out

SAMPLE SYSTEM CONFIGURATION 2

Integrate Multiple CAV6.6’s

This configuration uses an additional CAV6.6 to add six additional amplified zones, controlled through UNO-S2 Keypads. The source compo- nents are connected to both CAV6.6s with RCA cables using the source in/loop out to intercon- nect the audio/video signals.

RNET Link In and Link Out

Multiple CAV6.6s can be integrated as the two shown in this configuration. An RJ-45 CAT-5 patch cable allows for communication between the two CAV6.6s. System commands such as paging, ALL OFF, ALL ON, IR control, and PC control are transferred from one CAV6.6 to another through the Link In and Link Out Ports using the patch cable.

Source Components

The same six audio/video source components are used for both CAV6.6s. The source com- ponents are connected to the Source Audio/Video Input Connections on the first CAV6.6 while the Audio/Video Source Output Connections from the first CAV6.6 are con- nected to the Source Audio/Video Input Connections on the second CAV6.6.

Components List:

2 - CAV6.6 Controllers

12 - UNO-S2 Keypads

6 - 845.1 Micro Emitters

Keypads

This configuration uses a single UNO-S2 Keypad per zone on each of the CAV6.6s. Each keypad is connected to the UNO System Keypad Port using the CAT-5 T568A RJ-45 wiring configura- tion. This gives complete control of each of the 12 UNO System Controlled Zones to the corre- sponding UNO-S2 Keypad.

Individual zone settings such as volume, source selection, on/off, tone control and amplification are controlled through the UNO System Keypad. IR controls for zone and source equipment are controlled through the UNO-S2 Keypad.

Programming Note: When programming multiple controllers with identical configurations, remove the RNET link cables between con- trollers before starting any controller program- ming procedures.

86