INSTALLER
UNO-S2 KEYPAD-INSTALLATION
UNO-S2 Keypad Connections
CAT-5 Connection
The UNO-S2 Keypad uses a 110-punchdown terminal to provide a simple installation and strong connection for CAT-5 cable’s eight con- ductors. Punchdown terminals require the use of a punchdown tool which has been provided with the keypad kit. Attach the CAT-5 cable to the 110-punchdown terminal on the UNO-S2 Keypad as shown, matching the conductor colors to the connection color guide. The keypad will not operate properly if the terminations deviate from the required connection order.
Caution:
Take care when using an impact 110 punchdown tool, as this may overspread the contact points. Use of the impact tool may propel stray bits of wire and jacket into the keypad’s chassis and possibly cause a short in the circuitry. Gently shake or blow air through the keypad chassis to remove stray wire before the keypad is installed into the junction box.
OS Update Port
The OS Update Port is is used to update the UNO-S2 Keypad operating system software in the future. When an update is released, it will be available online through the Document Center at www.russound.com. Look for the Technical Documents under Multi-source/Multi-room prod- ucts. The programming cable is available from Russound, Part #2500-120633.
Jumper Setting
The jumper settings on the back of the UNO-S2 Keypad can be set for “Run” and “OS Update.” The jumper setting must be in the “Run” position before the keypad is mounted into the junction box, and must remain set in “Run” to operate the keypad. The jumper will be set to “OS Update” only while updating the keypad’s operating systems.
Punchdown Tool
Jumper Setting (back of keypad)
Punchdown Tool | CAT-5 Connections (back of keypad) |
OS Update Port (front of keypad)
