For Network Printing (CLP-650N only)
You can attach your printer to a network using an Ethernet cable (UTP cable with RJ.45 connector).
The
Using an Ethernet Cable
1Make sure that both the printer and the computer are turned off.
2Plug one end of the Ethernet cable into the Ethernet network port on the left rear of the printer.
Turning the Printer On
1Plug the power cord into the power receptacle on the left rear of the printer.
2Plug the other end into a properly grounded AC outlet and turn on the power.
To the network
LAN connection
3 Plug the other end of the cable into a network LAN connection.
NOTE: After connecting the printer, you need to configure the network parameters on the control panel. See page 8.1. You can use the software supplied with the card. Refer to the Network Printer User’s Guide.
2.8
Setting Up Your Printer
CAUTION:
•Some parts inside of the printer may be hot when power is on, or after printing. Be careful not to burn yourself when working inside the printer.
•Do not disassemble the printer when it is turned on or plugged in. Doing so may give you an electric shock.
Printing a Demo Page
Print a demo page to make sure that the printer is operating correctly.
To print a demo page:
In ready mode, press and hold the On Line/Continue button ( 
) on the control panel for 2 seconds to print a demo page.
A demo page showing the printer’s features and capabilities is printed.
