Samsung DVD-VR330/XEB manual Setting Up the Audio Options, Digital Output, Dynamic Compression

Setting Up the Audio Options

Allows you to setup the audio device and sound status settings depending on the audio system in use.

You can also adjust the NICAM mode.

1		With the unit in Stop mode/No Disc mode, press
		the MENU	button.
2		Press the …† buttons to select Setup					, then press
		the OK or √ button.
			DVD-Recorder			Setup
			No Disc
			Programme	System		√
			Setup	Clock Set		√
				Language		√
				Audio		√
				Video		√
				Parental Control		√
				Install		√
			MOVE	OK	RETURN	EXIT
3		Press the …† buttons to select Audio					, then press
		the OK	or √ button.
		Audio setup menu will be displayed.
			DVD-Recorder			Audio
			No Disc
			Programme
				Digital Output	: PCM	√
			Setup	DTS	: Off	√
				Dynamic Compressiom	: On	√
				NICAM	: On	√
			MOVE	OK	RETURN	EXIT
		Press the …† buttons to select the desired audio
	4 option, then press the OK				or √ button.

5 Press the …† buttons to select the desired item, then press the OK or √ button.

■ Press the RETURN or œ button to return to the

Note previous menu. Press the MENU button to exit the menu.

Digital Output

• PCM	:	Converts to PCM (2CH) 48kHz
		audio. Select PCM when using the
		Analog Audio Outputs.
• Bitstream :		Converts to Dolby Digital Bitstream.
		Select Bitstream when using the
		Digital Audio Output.

	Be sure to select the correct Digital Output or
Note	no audio will be heard.

DTS

•Off : Doesn’t output digital signal.

•On : Outputs DTS Bitstream via digital output only. Select DTS when connecting to a DTS Decoder.

			System
		When DTS soundtrack is played, sound is not
Note		output from Analog Audio Output.
			Setup
	Dynamic Compression

This is only active when a Dolby Digital signal is detected.

•On : When Movie soundtracks are played at low volume or from smaller speakers, the system can apply appropriate compression to make low-level content more intelligible and prevent dramatic passages from getting too loud.

•Off : You can enjoy the movie with the standard Dynamic Range.

NICAM

NICAM programmes are divided into 3 types. NICAM Stereo, NICAM Mono and Bilingual (transmission in another language).

NICAM programmes are always accompanied by a standard mono sound broadcast and you can select the desired sound.

•On : NICAM mode

•Off : Only set at this position to record the standard mono sound during a NICAM broadcast if the stereo sound is distorted due to inferior reception conditions.

English - 31