Connecting to a power source

You should use the rechargeable battery SLB-10A supplied with the camera. Be sure to charge the battery before using the camera.

SLB-10A rechargeable battery Specification

Model

SLB-10A

Type

Lithium Ion

Capacity

1050mAh

Voltage

3.7V

Charging time

Approx. 150MIN

(When the camera is turned off)

 

 

Recording

Conditions

 

time

 

 

 

 

 

Movie

Approx. 125

Using the fully charged battery

MIN

640x480 image size 30fps frame rate.

 

 

 

 

These figures are measured under Samsung’s standard conditions and shooting conditions and may vary depending on the user’s methods.

These figures are measured under OIS shooting condition.

Several videos were recorded in succession to determine the total recording time.

Number of images and battery life: Using the SLB-10A

 

Battery life

 

 

/Number of

Conditions

 

images

 

 

 

Using the fully charged battery, Auto

 

Approx. 135

mode, 10M image size, Fine image

 

quality, Shot to shot interval: 30sec.

Still image

MIN/

Changing the zoom position between

Approx. 270

the Wide and the Tele after every shot.

 

 

shots

Using the flash on every second shot.

 

 

Using the camera for 5 minutes and

 

 

then Powering it off for 1 minute.

 

 

 

Important information about battery usage.

When the camera is not used, turn off the camera power.

Please remove the battery if the camera will not be used for long periods. Batteries can lose power over time and are prone to leaking if kept inside the camera.

Low temperatures (below 0°C) can affect the performance of the battery and you may experience reduced battery life.

Batteries will usually recover at normal temperatures.

During extended use of the camera, the camera body may become warm. This is perfectly normal.

012

Page 13
Image 13
Samsung HZ10W manual Connecting to a power source, SLB-10A rechargeable battery Specification, 012