Samsung RF31FMEDBBC, RF31FMEDBSR, RF31FMESBSR user manual With the door opened, setting up

With the door opened

1.Remove the 3 screws holding down the TOP TABLE ( 1 ) and separate the connected wires.

1

2.Disconnect the two connectors ( 2 ) on the left side door. To remove the water coupler from the hinge, twist and pull it from the hinge. Remove the water line ( 3 ) while pressing the marked part ( 4 ) of the water line coupler.

If a red clip is on the coupler, you must CAUTION remove it before removing the tube.

2

Red Clip

(1/4")

3

4

Place the door, inside facing up, on a non-
CAUTION scratching surface.	01
Door Middle Hinge	SETTINGUP
	Auto Closing Hinge
Check the direction

-If the Auto Closing Hinge is aligned to be vertical as shown in the figure, align it to be parallel by using the Door Middle Hinge. (Refer to No.5 for the disassembly of the Door Middle Hinge)

Do not use a flat head screwdriver to align CAUTION the Auto close Hinge. It may get damaged.

Use the Door middle Hinge instead.

3.Pull and remove the hinge lever ( 5 ). Remove the ground screw ( 6 ) attached to the upper left door hinges with a philips screwdriver (+). Remove the upper left and right door hinges ( 7 ).

5

6

5. Remove the screw ( 8 ) attached to the

lower left and right door hinges with a philips

screwdriver (+). Remove the 2 hex head bolts

7

4.Open the door (more than 90°), lift from the

middle hinge and remove the door.

-Due to its design features, you can disassemble and re-assemble the door when the door is open. (The holes in the Door Shaft and the Door Middle Hinge are deliberately tilted at specific angles so that it is difficult to disassemble and re-assemble with the door closed.)

( 9 ) attached to the lower left and right door

hinges with an allen wrench (3/16”). Remove

the lower left and right door hinges ( 10 ).

10

8

9

Allen wrench

setting up _11

DA68-02894A-09.indb 11 2013. 12. 3. ￿￿ 8:45