System Information
Software Version
B3.07-K1.40-V2.17_0702101326
Broadcast Format NTSC
Mac Address 00:00:FO:54:FF:FF
OK Cancel
System Information and Setup
USB S/W Upgrade
Version
83.07-K1.40-V2.17C_0703141732
Device Information
Device No Used/Total Erase Usage
ATA 1 295.00K/139.92G Internal
USB Memory 1 0.00/494.98M Backup
Cancel
Storage Setup
OK
Disk End Mode
OverWrite
Disk End Beep Off
Alarm Setup HDD Location Map Exit
No. Model Capacity Status
1 ST3250823ACE 250.05G Good
2 ST3160212ACE 160.04G Good
3 DVD RW - -
4 ST3250823ACE 250.05G Good
HDD Installation Information
NG None
Duration 10 sec
OK
Cancel
Alarm Setup
Check None
Duration 10 sec
Exit
HDD Location Map
05 MENU SETUP
menu setup _23
System Information and Setup
This setup window provides the following setting
items:
Software Version: Displays the current
software version. The value cannot be
changed.
Broadcast Format: Displays the current
broadcast format (NTSC/PAL). The value
cannot be changed.
Mac Address: 6-Byte hardware address. The
value cannot be changed.
USB S/W Upgrade
You can update the software using a USB
device. If there is no device, None is displayed.
If the USB memory has an upgrade software,
its version is displayed.
To upgrade the software stored in the USB
device, select the check box on the right and
press OK.
Storage Setup
You can configure the storage device related
settings.
Device Information
Displays the number, capacity, and usage
of ATA and USB devices. (The total capacity
displayed may be lower than the actual
capacity because the DVR uses some portion
of it for internal purpose.) After selecting Erase
for each device, you can remove the data
on it. In case of USB device, you can set the
usage for extension or backup. If you change
the usage of the device, the stored data will be
removed.
Disk End Mode
- Stop: Stops recording when the disk is full while
recording is still in progress.
- Overwrite: Deletes the previously recorded data
to store new data when the disk is full during
recording.
Disk End Beep
- On: Beeps when the disk is full while recording.
- Off: Although the disk is full while recording, it
doesn’t make beep sound.
HDD Installation Information
When you click ( ), The HDD Installation
Information displays on the screen. Then you can
see the model name, the capacity, and the status
of the HDD in your DVR. The status displays Good,
Not good, and Check. In the status of Not good,
you should replace the HDD. In the status of Check,
you should replace the HDD or check periodically.
After clicking the Alarm Setup, you can set the
alarm and the duration while the status is Not good
or Check. If you click the HDD location map, it
displays the information about the HDD installation.
When a problem occurs, you can see which HDD
has a problem.
The capacity of the HDD may differently
appear in the Storage Setup menu and
HDD Installation Information menu.
SHR-5162_Eng.indb 23 2007-06-18 ｿﾀﾀ・11:48:14