Cable Color Scheme, Pins Signal Cable Color | Samsung SSA-R2010/EXP

CABLE COLOR SCHEME

❖ 2-PIN Connector

I/O Pins		Signal	Cable Color

Power (+12V)	DC +12V		Red

Earth-grounding	GND (-)		Black

❖ 6-PIN Connector

	I/O Pins			Signal	Cable Color

	EX Input Wiegand DATA0		EX-DATA0		Pink

	EX Input Wiegand DATA1		EX-DATA1		Sky Blue

	NC				Brown

	NC				Blue
	RS-485	RS-485 A(+)	RS-485	A(+)	Yellow

		RS-485 B(-)	RS-485	B(-)	Gray
		RS-485 B(-)	RS-485	B(-)	Gray

❖8-PIN Connector

I/O Pins	Signal	Cable Color

Wiegand DATA 0	DATA-0	Green

Wiegand DATA 1	DATA-1	White

ERROR SIGNAL OUT	ERROR SIGNAL OUT	Orange

OK SIGNAL OUT	OK SIGNAL OUT	Orange with Black Stripes

TAMPER OUT	TAMPER OUT	Purple

EX_LED_CONTROL	EX_LED_CONTROL	Blue with White Stripes

EX_BUZZER_CONTROL	EX_BUZZER_CONTROL	White with Red Stripes

EX_SYS_CHANGE_IN	EX_SYS_CHANGE_IN	Gray with Red Stripes

❖TCP/IP (8PIN Connector) RJ45 cable connected

PRODUCT INTRODUCTION

English _ 9

Image 9

Samsung SSA-R2010/EXP manual Cable Color Scheme, Pins Signal Cable Color

Contents

Please visit our website Biometric Reader Safety information Safety information This device may not cause harmful interference, Important Safety Instructions Contents Product introduction Features WHAT’S Included Cables Quick Guide CD ManualMaster Card Ferrite Cores X AT a Glance Front PanelDisplays the status of the system operation Rear Panel Cable Color Scheme Pins Signal Cable Color Cable Selection Termination Resistor Installing the Wall Mount Host PC EARTH-GROUNDING the Communication Cables Connection Overall Wiring Diagram Input Connection PowerController Connection of External LED control Wiegand Data Output Connection Output Connection External Reader Connection Connecting to the External Reader RS-485 Communication Port Connection Standalone Communication Line Connection RS-485 Communication Port Connection Multiple Units Hub Host PC RJ45 RJ45 RJ45 TCP/IP Communication Port Connection Refer to Communication Address Setup. on Initializing the System Using the DIP SwitchInitialization Master ID Registration Mode Reader ModeDisplay and Operation Status of READER/REGISTER To REGISTER/DELETE the Master ID Card Communication Address Setup Reader Mode and Authentication If the card is not registeredPresent the registered card to the reader User management Registering the IDTo Register the ID Card Along with the Fingerprint Successfully To Delete ID Timing Diagram Wiegand Output DefaultOutput format Data Type 26-bit /34-bit Other information HOW to Register the Fingerprint Troubleshooting TroubleshootingProblem Action Problem Product speciﬁcations Product Specifications Correct disposal of batteries in this product