READER MODE AND AUTHENTICATION
Reader Mode
1.In Reader mode, any recognized user ID or status will be transmitted to the controller.
2.If the user ID and fingerprint are authenticated, the corresponding card ID will be displayed.
3.If they are not authenticated, an error signal will be output.
How to get authenticated if set to RF Only mode or if registered in RF Only mode
1.Present the registered card to the reader.
2.When the card is authenticated successfully, you will hear a long beep with the green indicator turned on.
3.The user ID will be displayed according to the specified output format.
How to get authenticated if set to RF+ Finger mode and registered in RF+ Finger mode
1.Present the registered card to the reader.
2.When the card is recognized, the red lamp on the scanner turns on.
3.Place the registered fingerprint on the scanner.
4.When the fingerprint is authenticated successfully, you will hear a long beep with the green indicator turned on, and the user ID will be displayed according to the specified output format.
5.If the fingerprint is denied, you will hear a beep twice with the orage indicator blinking twice, and the fingerprint error signal (Low Active) will be output for 500ms.
If the card is not registered
1.If you will hear a beep twice with the orange indicator blinking twice when presenting the card to the reader, this indicates that the card is unregistered or already deleted.
2.For an unregistered card or denied fingerprint, the reader will output the fingerprint error signal (Low Active) for 500ms.
INITIALIZATION
English _ 23
