To Delete ID, Successfully | Samsung SSA-R2010/EXP manual

TO DELETE ID

1.Check if the green and orange indicators are all turned off when the reader turns on.

	2. Present the master card to the reader. You will hear the following		REGISTRATION AND
	voice message with the green and orange indicators blinking.	Q	REGISTRATION AND
		Q	DELETION MODE, SCAN
			YOUR CARD

3.Present a registered user card to the reader. When you hear the following message with a beep four times, the user is deleted

successfully.

Q ID DELETED

•When the ID is deleted, the ﬁngerprint data will be deleted too.

4.Repeat step 3 above if you want to delete another user.

5.When the ID deletion is completed, present the master card to exit the registration mode.

USER MANAGEMENT

English _ 25

Image 25

Samsung SSA-R2010/EXP manual To Delete ID, Successfully

Contents

Please visit our website Biometric Reader Safety information Safety information This device may not cause harmful interference, Important Safety Instructions Contents Product introduction Features Cables Quick Guide CD Manual WHAT’S IncludedMaster Card Ferrite Cores X Front Panel AT a GlanceDisplays the status of the system operation Rear Panel Cable Color Scheme Pins Signal Cable Color Cable Selection Termination Resistor Installing the Wall Mount Host PC EARTH-GROUNDING the Communication Cables Connection Overall Wiring Diagram Input Connection PowerController Connection of External LED control Wiegand Data Output Connection Output Connection External Reader Connection Connecting to the External Reader RS-485 Communication Port Connection Standalone Communication Line Connection RS-485 Communication Port Connection Multiple Units Hub Host PC RJ45 RJ45 RJ45 TCP/IP Communication Port Connection Refer to Communication Address Setup. on Initializing the System Using the DIP SwitchInitialization Master ID Reader Mode Registration ModeDisplay and Operation Status of READER/REGISTER To REGISTER/DELETE the Master ID Card Communication Address Setup If the card is not registered Reader Mode and AuthenticationPresent the registered card to the reader Registering the ID User managementTo Register the ID Card Along with the Fingerprint Successfully To Delete ID Timing Diagram Wiegand Output DefaultOutput format Data Type 26-bit /34-bit Other information HOW to Register the Fingerprint Troubleshooting TroubleshootingProblem Action Problem Product speciﬁcations Product Specifications Correct disposal of batteries in this product