Installing a hard disk
No default hard disk is installed at the time of purchase. To purchase and install a hard disk, consult the dealership where this unit was purchased.
Make sure the unit is turned off before installing the hard disk.
1Unfasten the cover of the unit.
Set the mode of the hard disk to be installed to
"Master". For more information, read the hard disk installation manual.
2Fix the brackets to the hard disk using the supplied HDD mounting bracket screws (A).
A
A
3Connect the supplied IDE cable (B) and HDD power cable (C) to the hard disk and fix the hard disk to the unit using the supplied HDD fixing screws (D).
D
D
Black
B
Blue
C
Warning
The hard disk is a precision instrument. To avoid damage, handle the hard disk with care and do not expose it to shock.
Do not block the ventilation holes and do not allow the cooling fan to stop. Doing so may cause heat build up and may shorten the life expectancy of the hard disk.
GThis unit is designed to be positioned horizontally. Do not position vertically.
GDo not expose to shock or vibration and do not transport while power is turned on.
Always turn the power off when moving in and out of racks or other shelves.
GDo not remove the power plug while recording or playing images back.
GDo not move the unit for approximately 30 seconds after turning the power off.
The hard disk continues to rotate for a short duration after the power has been turned off. The unit is further susceptible to damage through shock and vibration during that period. It is imperative that you do not move the unit during that time.
GDo not expose to shock or vibration.
Avoid placing this unit directly on the floor. Make sure that the four stands attached to the base of this unit are used when placing it on the floor.
GAlways use the original packaging (packaging supplied at the time of purchase), when shipping the unit.
Make sure you use the packaging materials supplied at the time of the original purchase when shipping the unit or a single internal component of the unit. Select a shipping method that will cause the least amount of shock to the unit during shipping.
Consult the dealership where this unit was purchased for hard disk replacement.
•The hard disk is vulnerable to static electric shocks. Take appropriate measures to prevent exposure to static electricity.
•Unpackaged drives should be placed horizontally with their base plate facing upwards on top of a soft cloth. Exposing the hard disk to shocks and vibration may cause breakdowns.
•Do not expose the drive to shocks and/or vibrations when removing/tightening the screws at the time of hard disk replacement. Firmly tighten the screws after replacement.
2