RECORD settings
●Setting the MOTION ZONE (P13)
Select the zone where the motion sensor is active. It is necessary to set a detection frame when PARTIAL ZONE is selected.
FULL ZONE:
The motion sensor is active on the whole screen.
PARTIAL ZONE:
The motion sensor is active in the set detection frame.
●Setting the MOTION SENSITIVITY
To select MOTION SENSITIVITY and select the level of detection sensitivity of the motion sensor.
Selections: 1/2/ ... 8/9 (Low sensitivity level)
●Setting the SENSOR TYPE
To select the detection mode when connecting an external sensor.
To select SENSOR TYPE and select the detection mode.
N/O: Open type (normal open) when sensor is connected
N/C: Closed type (normal close) when sensor is connected
●Setting the PRE RECORD
To select PRE RECORD and select
ON: Starts recording approximately 5 seconds before the internal motion sensor or the external sensor detector is triggered. (Fixed to 1 ips)
OFF: No
●Setting the POST EVENT RECORD
To select POST EVENT RECORD and select in how much time, after the sensor detection, the recording will start.
Selections: 2/3/4 ... 30 SECONDS
●Setting the ALARM
To select ALARM and select the output mode when an alarm is triggered.
ON: Outputs a signal to an external alarm device when an internal motion sensor or an external sensor detects.
OFF: Does not output a signal to an external alarm device.
●Setting the ALARM DURATION
To select ALARM DURATION and select the length of the alarm signal output.
Selections: 1/2/3 ... 58/59/60 SECONDS
●Setting the AUDIO
To select AUDIO and set the audio sound recording.
ON: Records the audio of live videos
To listen to audio sound connect an external microphone or speaker.
OFF: Does not record the audio of live videos.
CSetting the TIMER SET
To perform BY SCHEDULE settings.
The recording schedule of each channel can be set using settings by the hour. (P15)
28