Part Names and Functions

Terminals and Connectors

 

 

 

q

w

 

 

 

 

e

 

 

 

 

r

 

 

 

 

t

!0

o

i

u

y

qSERIAL PORT IN TERMINAL

If you control the projector from a computer, you must connect a cable (not supplied) from your computer to this RS-232C terminal.

wSERIAL PORT OUT TERMINAL

This terminal outputs signal from SERIAL PORT IN. More than two projectors can be controlled with one computer by connecting SERIAL PORT IN of another projector to this RS-232C terminal.

eUSB CONNECTOR (series B)

USB connector is to used to service the projector.

rR/C JACK

When using the wired remote control, connect the wired remote control to this jack with a remote control cable (not supplied).

tLAN PORT

Connecting the Ethernet cable See the owner’s manual of “Network Set-up and Operation” for details.

yS-VIDEO JACK

Connects the S-VIDEO output signal from video equipment to this jack (p.21).

u5 BNC JACK

Connects the component or composite video output signal from video equipment to VIDEO/Y, Pb/Cb, and Pr/Cr jacks or connect the computer output signal (5 BNC Type [Green, Blue, Red, Horiz. Sync, and Vert. Sync.]) to G, B, R, H/HV, and V jacks (pp.20–21).

iANALOG TERMINAL

Connects the computer (or RGB scart) output signal to this terminal (pp.20–21).

oHDMI TERMINAL

Connects the HDMI output signal from video equipment to this terminal. (pp.20–21)

!0DIGITAL (DVI-D) TERMINAL

Connects computer output (Digital/DVI-D type) to this terminal (p.20).

HD (HDCP Compatible) signal can be also connected (p.21).

11

Page 11
Image 11
Sanyo HF10000L owner manual Part Names and Functions, Terminals and Connectors