Installation

Positioning Projector

SCREEN

 

This projector is designed to project on a flat projection surface.

Note:

Brightness in room has a great influence on picture quality. It is recommended to limit ambient lighting in order to provide the best image.

Lens Shift Adjustment

Projection lens can be moved from side to side and up and down with the motor-driven lens shift function. This function makes the positioning of images easy on the screen. The amount of lens shift range varies depending on the lens. The shift ranges shown below apply to the LNS-S03 lens. (See page 28)

The display position can be shifted upward up to 50% elevation of the display.

The display position can be shifted downward up to 50% low level of the display.

When the lens is shifted to top.

When the lens is shifted to bottom.

The display position can be shifted to the left in up to 10% width of the display.

The display position can be shifted to the right in up to 10% width of the display.

When the lens is shifted to leftmost.

Picture Level and Pitch Adjustment

The projection angle is adjustable up to 2.8 degrees upward and downward respectively by rotating front and back feet .

To raise the projector, rotate the feet clockwise.

To lower the projector or to retract the adjustable feet, rotate the feet counterclockwise.

To correct keystone distortion, press the KEYSTONE button on the remote control or select Keystone from the menu (see pages 31, 45, 52).

Do not rotate the adjustable feet when you see the red line on the adjustable feet. The adjustable feet may fall off.

When the lens is shifted to rightmost.

REAR ADJUSTABLE

FEET (Refer to p.10)

ADJUSTABLE

FEET

18

Page 18
Image 18
Sanyo HF10000L owner manual Installation, Positioning Projector, Lens Shift Adjustment, Picture Level and Pitch Adjustment