Settings
Lamp life control
Select the lamp operation when the total lighting time of a lamp exceeds the recommended total hours of use.
Mode 1 | A lamp can be turned on even after |
| exceeding the recommended total hours of |
| use. |
Mode 2 | A lamp can be turned on even after |
| exceeding the recommended total hours of |
| use. But the projector turns off automatically |
| after 3 minutes. |
✔Note
•Lamp mode cannot be changed for a while after turning on the projector. Lamp needs some time to stabilize after the power is turned on. Stored lamp mode will be active after the lamp is stabilized.
•If Mode 2 has been selected and the projection lamp exceeds the recommended total hours of use, the replacement icon will be displayed at the time of
Lamp interval
In
Off | Turns off the lamp switching function |
XXXXH | When the cumulated lighting time of the lamp |
| reaches the specified time, automatically uses |
| the other lamp. (Options: 24H, 200H, 500H, |
| 1000H, 2000H) |
✔Note
The projector cannot switch between the lamps at exactly the same time as you specified. The time specified here is approximate.
Picture in Picture
This function is used to project two images simultaneously by placing a separate small sub screen within or next to the main screen.
Use the Point ed buttons to select Picture in Picture and then press the SELECT button to display a dialog box. You can also display the dialog box by pressing and holding the PIP button on the remote control for more than 3 seconds.
( In P in P, the larger picture is main picture, and the smaller one is sub picture; in P by P, the left picture is main picture, and the right one is sub picture.)
Picture in Picture
Shows the selected mode (Off/User
55
