Appendix

 

The end of lamp life is approaching. Replace the lamp with a new one promptly.

appears on the screen

(See page 75)

 

 

 

 

The filter is out of scroll. Replace the filter cartridge with a new one promptly.

appears on the screen

(See pages 71-73)

 

 

– Adjust the focus of the projector.

 

– Check Projection Lens to see if it needs cleaning.

The image is out of focus.

Note: Moving the projector from a cool temperature location to a warm temperature

location may result in moisture condensation on Projection Lens. In such cases,

 

leave the projector OFF and wait until condensation evaporates.

 

– Projecting from excessive slant angle to the screen may cause keystone distortion and

 

partial imperfect focus.

 

 

 

– Check if “Contrast” or “Brightness” are adjusted properly. (See pages 40, 48)

 

– Check if “Image level” is selected properly. (See pages 39, 47)

The image is not bright

– Check the Lamp control function. ( See “SETTING” section on page 54)

– Check the Lamp 1/2 Replace indicators. If it lights, the end of lamp life is approaching.

enough.

Replace the lamp with a new one promptly. (See page 75)

 

 

– The image is darker when 1 lamp mode is selected, compared with 2 lamp mode.

 

Check the lamp mode at SETTING section on page 54.

 

 

The color is strange.

– Check the Input signal, color system, video system, or computer system mode.

 

 

The image is Left/Right

– Check the Ceiling / Rear function. (See pages 45, 52)

reversed.

 

The image is Top/Bottom

– Check the Ceiling function. (See pages 45, 52)

reversed.

 

The image is distorted or

– Check “PC Adjust” menu or “ Screen” menu and adjust them.

runs off.

 

Auto PC adjustment function

– Check the Input signal. Auto PC Adjustment function cannot work when 480p, 575p,

does not work.

720p, 480i, 575i, 1035i, 1080p, or 1080i is selected or when the digital signal is input

into HDMI/DVI-D terminal. (See page 36)

 

 

 

Some displays are not seen

– Check the Display function (see page 53).

during the operation.

 

The setting does not remain

– Make sure you selected “Store” after adjusting settings. Some settings cannot be

after turning off power.

stored if not registered with “Store”.

 

 

Power management function

– Power management function cannot work while “Freeze” function is running or the

does not work.

shutter is closed.

Image disappears

– Check the power management function in the Setting. The power management is set

automatically.

to "On" at the factory.

Capture function does not

– Check the connection to see if there is signal.

– Capture function is not available when the Picture in Picture function is set to one of

work.

User1 - 5.

 

 

 

Some menus cannot be

– Each of the Video Input and Computer Input has a limit on selectable menus.

selected.

 

 

 

80

Page 80
Image 80
Sanyo HF10000L owner manual Appendix, Image is out of focus