Receiving a Ready Link Call

To receive a Ready Link call:

1.Make sure your phone’s Ready Link mode is enabled. (See “Setting Ready Link Mode” on page 163.)

2.When you receive a Ready Link call from a contact,“R-Link Call,” the contact’s name, and the Ready Link number are displayed. (You do not need to take any action to answer the call.)

When you receive a group call,“Group Call,” the group member’s name, and the Ready Link number are displayed.

3.If the person placing the call has kept the floor (held the Ready Link/Recorder button), you will see the contact’s name and Ready Link number along with “has floor,” and you will hear the caller speaking.

4.When the caller finishes speaking and releases , you will see

“Floor is open” on the display screen. Press and hold to take the floor and reply to the caller. (You will see “You have floor” and hear a tone confirming that you may speak.)

5.When the conversation is finished, press .

Tip:

You can also receive a Ready Link call with the phone closed. Press and

 

hold the Ready Link button to take the floor when the floor is open.

 

 

Note:

You can change the volume and the speaker setting while a Ready Link call is activated. Volume: Adjust the voice volume by using the Side Volume key or by pressing the navigation key up or down (except when you are pressing and holding the Ready Link button). Speaker: Switch the speaker on or off by pressing the Speaker button.

170 Section 2J: Using Ready Link

Page 186
Image 186
Sanyo M1 manual Receiving a Ready Link Call, To receive a Ready Link call, When the conversation is finished, press