Sanyo PLCXL51 owner manual Error information, Error messages, Cause and corresponding

Error information

Error information

Error messages	Cause and corresponding
	Error when the communication is executed. The parameter setting (host
Set up the parameter.	name, capture port) has not been set.
	➔ Check parameter setting (+p.88)
It has not been registered to PJ as a	Error when Start Communication or Start real time capture is executed. The
	IP address of the computer has not been registered.
group.
	➔ Register the IP address by using the web browser (+p.95)
Cannot be displayed as PJ is under	Error when Start Communication or Start real time capture is executed. The
	other capture, viewer or memory viewer function is now operating.
display.
	➔ Wait until the communication function is available.
	Cannot establish the connection with the projector when the Start
Cannot connect to PJ.	communication is executed, Terminate Communication, Capture transfer,
	Start real time capture or Terminate capture.
	➔ Check connection of the network cable.
	Cannot transfer the data to the projector when the Start Communication,
Cannot transfer data to PJ.	Terminate Communication, Capture transfer, Start real time capture or
	Terminate capture is executed. The time-out period is 10 seconds.
	➔ Check the connection of the network cable.
	Cannot receive the data from the projector when the Start
	Communication, Terminate Communication, Capture transfer, Start real
Cannot receive data from PJ.	time capture or Terminate capture is executed. The time-out period is 10
	seconds.
	➔ Check the connection of the network cable.
Other PC has authority.	When executing the Terminate Communication, you cannot quit the
Cannot complete "Network
	communication because other computer has an authority
Communication".
Other PC has authority. Cannot	Other computer has an authority.
obtain authority.
Invalid port number	When the parameter is set, the reserved port number is specified.
	➔ Check the parameter setting (+p.88)
PJ has not started Network	The projector might have turned off during the communication.
Communication. Close the window
	➔ Check the projector power and re-execute "Start communication".
and open it again.

107