IF YOUR COPIER DOES NOT OPERATE AS YOU WANT
The following table shows the causes of problems and the corrective actions when your copier does not operate as you want.
If the same problem remains even when you take the corresponding action, contact your service representative.
Dirty Copies
Cause | Corrective action |
|
|
The copy density is too dark. Reduce the copy density. → See page 9.
The exposure glass is dirty. Clean the exposure glass. → See page 53.
Blurred Copies
Cause | Corrective action |
|
|
The copy density is too light. Increase the copy density. → See page 9.
The toner is running short. Replace the toner cartridge. → See page 43. | |
| |
Rough, coated, or edged Use only recommended paper.→ See page 5. | |
paper is used. |
|
|
|
The copy paper is damp. | When you copy onto roll paper, cut the damp |
| area. → See page 39. |
|
|
The fusing temperature | is Switch the fusing temperature according to the |
not appropriate. | paper type. → See page 7. |
Spotty or Partially Blank Copies
Cause | Corrective action |
Inappropriate copy paper is Set paper of the same size as, or larger than the | |
used. | original. |
The original feed direction Set the original to match the feed direction of the does not match the paper paper to be copied on.
feed direction.
The leading margin is not Adjust the leading margin. → See page 12. appropriate.
WHAT TO DO IF SOMETHING GOES WRONG 31
