![](/images/backgrounds/151598/bg20.png)
4Specify values for each setting.
You can store the following settings with the Program function. For the
way to specify values, see the corresponding pages.
•Sample copying → See page 21.
•Partial copying (The start and end points cannot be stored) → See page
19.
•Paper feeder → See page 22.
•Copy exit → See page 10.
•Margins → See page 12.
•Cut type → See page 14.
•Number of copies → See page 8.
•Copy density → See page 9.
•Fusing temperature → See page 7.
✏You can also store the paper type and roll width. However, these
settings cannot be changed with the Program function. When you
specify a paper feeder, the paper type and roll width specified with the
Paper Type/Roll Width Entry function (see page 22) are stored.
5Press the Enter key.
The copy settings are stored.
6If you store settings for another
program number, repeat 2 to 5.
7Press the Program key.
The lamp on the Program key
lights.
✏The settings are also stored
when you press the Program
key instead of the Enter key.
USING THE PROGRAM FUNCTION
COPYING 25