Savin 8700W PAPER/TONER

PAPER/TONER

Notes on Paper

SDo not set the following paper. Otherwise, a paper jam might occur.

•Bent, folded, or creased paper •Torn paper

•Perforated paper •Non-smooth paper

•Slippery paper •Thin paper that has low stiffness

SDo not make a copy on paper with any kind of coating, such as thermosen-

sitive paper, art paper, aluminum foil, and carbon paper. Otherwise, a fault

might occur.

SIf you make a copy on edged paper, the copy might be creased or a part of

the image might not be copied.

SWhen you use roll paper, the roll must be black.

SWhen film is delivered from the copier, it is softened due to the fusing heat.

Place the film on a flat surface until the remaining heat is removed from the

film.

SIf you make a copy on rough paper, the copy image might be blurred.

SKeep paper away from humidity. Once you unpack the container of paper,

store the paper in a polyvinyl bag in the following locations:

•Location free from direct sunlight •Location with the humidity of 70

% or less

•Flat location

Toner

SStore toner cartridges levelly in the following locations:

•Location free from direct sunlight •Locations the toner could be

subjected to temperature of over

35 °C, 95 °F

R

WARNING: Do not incinerate toner or toner containers. Toner dust

might ignite when exposed to open flames.

Dispose of the used toner container according to local

regulations.

❐

Do not store toner where it will be exposed to heat.

❐

Do not eat or swallow toner, and keep it out of reach of

children.

54 MAINTAINING YOUR COPIER

Contents

Main I 0 INTRODUCTION SAFETY INFORMATION R q r R m r s m r q m m Page TABLE OF CONTENTS COPYING WHAT TO DO IF SOMETHING GOES WRONG MAINTANING YOUR COPIER SPECIFICATIONS COPIER EXTERIOR Main Unit Operation Panel Indicator Panel COPIER EXTERIOR COPYING BASIC Recommended Originals 1 2 3 Page Switching the Fusing Temperature 1 Setting the Number of Copies (Repeated Copying) Setting a Leading/Trailing Edge Margin 1 2 3 4 COPYING ONTO ROLL PAPER Synchro Cutting 1 2 3 Preset Cutting 1 2 3 Variable Cutting 1 Page PARTIAL COPYING 1 2 3 4 SAMPLE COPYING 1 2 3 PAPER TYPE/ROLL WIDTH ENTRY FUNCTION 1 2 3 4 Page USING THE PROGRAM FUNCTION Programming a Collection of Copy Settings 1 2 3 Recalling Programmed Settings COPYING WITH MANUAL FEED 1 2 Page Page WHEN THE "WAIT" INDICATOR IS LIT IF YOUR COPIER DOES NOT OPERATE AS YOU WANT Dirty Copies Blurred Copies Spotty or Partially Blank Copies Waved Copies Creased Copies WHEN A OR x IS LIT When A and Are Lit When x and Are Lit Page When Is Lit 1 2 3 WHEN C IS LIT 1 2 3 4 Cutting the Paper Automatically Cutting the Paper Manually 9 a WHEN D IS LIT OR BLINKING 1 2 Page Page Page Page FUNCTIONS THAT CAN BE RESET COPY MAGNIFICATION/CUT LENGTH ADJUSTMENT 1 2 3 4 DOS AND DONTS Page DAILY MAINTENANCE 1 2 PAPER/TONER Notes on Paper Bent, folded, or creased paper Perforated paper Slippery paper Location free from direct sunlight Toner WHERE TO PUT YOUR COPIER Installation Conditions Disposal Space Required for Installing the Copier Page Page Page SPECIFICATIONS Spirio 700W 3rd Roll Feeder OTHER OPTIONS