Scientific Atlanta D9225 manual 6HDUFK6HWXSPHQXand, ¼$ERXWWKH6HDUFKRSWLRQ

6HDUFK￿6HWXS￿PHQXand

Automated signal search op ions available from the Search Setup menu for seToSteptingdisplay1234...upDisplayMovetoyourtheSearchHeadtheRceivereSMainMenundSetupSetupSatatusellitemenÖ(FigureandandRecpress5)iv.sSELECTrs(see also...“Receiver Setup menu”).

Available options: Move to Exit and press SELECT (or press 1 and then SELECT) to return toRangethe previous menu.

You can view or change the current setup. Your dealer/reseller or local service provider can vise you about what receiver settings you may need to change. The followingâSearchLowUppI/QSelectSearchModeTypesetup information is displayed on-screen.

¼$ERXW￿WKH￿6HDUFK￿RSWLRQ

Searching for a signal with the “Search” option is used for restoring normal re- ceiver operation if the received signal is interrupted or lost, or is changed by the ￿￿local broadcast satellite services provider.

A signal search is enabled by setting the Search option to ON at the Search Setup menu, and is activated automatically only if the carrier signal is interrupted or lost for more than 20 seconds (with menus not displayed). If the lost carrier signal is recovered within 20 seconds, the receiver will attempt to synchronize with the last locked channel. If unavailable, the “NO CHANNEL” banner is displayed. If the

Figure14.SearchSetupmenudisplay

lost carrier signal is not recovered within this time, a signal search is activated automatically.

Once activated, the receiver begins searching for a signal associated with the cur- rent Network ID. When a possible match is found, the search is temporarily inter- rupted while the receiver attempts to synchronize with the found signal. If syn- chronization is successful, the signal status is displayed on-screen. Settings can be saved, as required while in the Search Setup menu before exiting to video (current channel). If receiver synchronization cannot take place, the signal is discarded and the signal search is automatically resumed.

If no signal is found, the signal search continues indefinitely, and must be manu- ally terminated. A signal search can also be manually terminated, or interrupted and resumed with different settings. To disable the search, set the Search to OFF. A search is also terminated automatically if the current channel is changed, or if the MENU button is pressed (see also “…About the Find option” and “…About the Signal State”).