1HWZRUN3UHVHWVPHQX
This menu lets you configure and store sets of network parameters to be used to define as many as 24 network signals. Each configuration set is called a “preset” and is uniquely identified by a preset number (0 to 23).
ure two or more networkMain presets, you must use the Network Presets menu. In a typical applic ion, y u would not ed to use the Network Presets menu.
If you h vetheonlyNetworkone networkPresetspresetmenuÖto configure, you could use the Receiver Setup menu instead of this menu. (S e also “Receiver Setup menu”.) However, to config-
Most of the func ions ed d o t up your Headend Satellite Receiver are avail-
StepToabledisplayfrom4321...MovetoDisplayNetheNetworkUserRceiverSetupP MenuPresetsStatusandmenu(eepressandandpressFigure5). YoupressSELECTcanSELECT.SELECTview. .or.change the current setup.
Available options: Move to Exit and press SELECT (or press 1 and then SELECT) to return to the previous menu.
â«*HQHUDOUXOHVIRUXVLQJWKH1HWZRUN3UHVHWVPHQX
The settings in fields Freq Mode, L.O. Freq #1, L.O. Freq #2, and Crossover can be changed only at the Receiver Setup menu. These setting are used for all network presets. If you set L.O. Freq #1 to a value less than 8 GHz, it is used as a
value greater than 8 GHz, it is used as a low
If you use
If your LNB has only one local oscillator, set both L.O.s to the same local os- cillator frequency.
Figure19.NetworkPresetsmenudisplay
âWhenever you change a setting that is common to both the Receiver Setup menu and the Network Presets menu, the setting is changed accordingly in
âboth menus.
The current band you are using at the Network Presets menu depends on the frequency defined. Any frequency between 0 and 8 GHz is
the frequency is
StepToset21..SetGoDLocaltownlinktheFreqReceiverSetupmenufreqModeto.
Whenthey u switchOscillatorbe ween presets, the frequencyfrequenciesÖmode in the Receiver Setup âmenu chang to downlink.
For sefieldmiliar wi h
