Care and Cleaning (coo oood)

Standard Twin Burners

(on some models)

CAUTION: DO NOT OPERATE THE BURNER WITHOIFF ALL BURNER PARTS AND DRIP

PANS (IF SO EQUIPPED) IN PIAC_E.

Grate

Drip pan

(on some models)

............Surface burner

On models with standard twin burners, the cooktop lifts up for easy access.

Turn all controls off before removing burner parts

and drip pans (ffso equipped).

To remove burned-on food, soak the surface burner

in a solution of mild liquid detergent and hot water° Soak the surface burner for 20 to 30 minutes, For

more stubborn stains, use a cleanser like Soft Scrub ® brand or Bon Anti ® brand. Rinse well to remove any traces of the cleanser that might dog the surface burner openings. Do not use steel wool because it will clog the surface burner openings and scratch the surface burners. If the holes become clogged, clean

them with a sewing needle or twist tie.

Before putting the surface burner back, shake out excess water and then dry it thoroughly by setting it in a warm oven for 50 minutes. Then place it back in the range, making sure it is properly seated and level

Check the flame pattern of each burner. If the flames are "jumpy" (not steady), clean the holes again with a sewing needle or twist tie°

Lift-Up Cool<top

(on models with standard twin burners)

The burner grates and drip be lifted off, maldng them

The holes in the surface burners of your range must be kept clean at all times for proper

ignition and an even,

unhampered flame.

You should dean the surface burners

pans (if' so equipped) can

easy to clean°

Clean these holes

Clean the area under the cooktop often. Built-up soil, especially grease, may catch on fire.

To make cleaning easier, the cook'top may be lifted upo

To raise the cooktop:

1.

Be

sure the

burners

 

are

turned

off.

2.

Remove

the grates.

3.

Grasp

the

two front

routinely,

especially

thoroughly

after

bad

splllovers,

on

each

burnen

which

could

clog these

 

 

holes. Wipe off surface burners. If heavy spillover

 

occurs, remove the surface burners from the range.

 

Burners

lift

out for cleaning.

Hft up the cooktop

and

then lift out the surface burners.

burner wells and lift up.

Some models have dua! support rods that wiI1 hold the

cooktop up while you clean underneath it.

After cleaning under the cooktop with hot, soapy

water and a clean cloth, lower the cooktop. Be carefiA not

to pinch your fingers. Lower cooktop gently to avoid

blowing out pilot flames (on models with standing pi!ots).

28

Page 28
Image 28
Sears 75478, 72671, 72675 Care and Cleaning coo oood, Lift-Up Cooltop, Turn all controls off before removing burner parts