Sears 75571, 72671, 72675 Installation Instructions coo 0u0d, Installing the Anti-Tip Device, Wall

Installation Instructions coo 0u0d)

STEP 9

Installing the Anti-Tip Device

WARNinG:

•	Range	must be	secured	with	an approved		Anti-
	Tip device.
•	Unless	properly	instated,	the	range	could	be
	tipped	by you	or a child	standing,		sitting	or

For cement or concrete construction, you will need a

114" x 1_" lag bolt and a I12" O.D. sleeve anchor,

which are not provided. Drill the recommended size hole for the hardware.

Install the sleeve anchor into the drilled hole and then

install the lag bolt through the device. The bolts must be

properly tightened as recommended for the hardware.

leaning on an	open	door.
• After installing	the	Anti-Tip	device, verify that it

Wallboard

Back of range

is in place	by		carefi_y		attempting		to	tilt	the	range
forward.
• This range		has		been	designed	to	meet	all
recognized		industry			tip standards		for	all	normal
conditions.
• The use of this device does not preclude tipping
of the range when not properly installed.
• If the Anti-Tip				device supplied with the range
does not fit this application,						use the universal
Anti-Tip		device		WB02X7909.
1. Mark the	wall		where		the RIGHT		EDGE		of	the
range is to be located. Be sure to allow for the
countertop		overhang			it: you intend		to	install		the
range next		to	cabinets.

Anti-Tip I

Slotted I_L_ _ 1_!_-.__ I

hoad _l llt

,orew f ll w.,,p,o,oI

Approx. 205 I

7._ 2W' , .,,/Marked edge of range

_bo4cmj _ /

2.Locate the outside edge of the device 2¼" (5.4 cm) toward the center of the range fiom the marked edge of' the range_

3.Using the device as a template, mark the position of the hole for the screw.

4.For wood construction, drill a pilot hole at an angle

of 20 degrees from the horizontal. A nail or awl may be used if a drill is not available,

Mount the Anti-Tip device with the screw provided°

Anti-Tip device

Wood screw

Wall#ate

5, Slide the range against the wall, and check for proper installation by grasping the front edges of the rear surface unit openings and calefu!Iy attempting to tilt the range forward.

WHEN ALL HOOKUPS ARE COMPLETED:

MAKE SURE ALL OF THE CONTROLS ARE

LEFT IN THE OFF POSITION.

MAKE SURE THE FLOW OF COMBUSTION

AND VEI'grILATION AIR TO THE RANGE IS

UNOBSTRUCTED.

Converting to LP gas

(or converting back to natural gas from LP)

This range leaves the factory set for use with natural gas_ If you want to convert to LP gas, the conversion

must be performed by a qualified LP gas installer.

The conversion instructions, sticker and LP orifices

can be found attached to the range next to the pressure regulator.

There is a second set of instructions included in the

envelope containing the product wiring diagrams on

the back of the range. Keep these instructions and the orifices in case you want to convert back to natural gas.

42