Installation Instructions o0 000d)
STEP 5
Check Ignition of Surface Burners
Operation of all cooktop and oven burners should be checked after the range and gas supply lines have been
carefully checked for leaks,
Hectric Ignition Models
Select a top burner knob and simultaneously push in and turn to I_.ITE position. You will hear a snapping sound indicating proper operation of the spark module. Once the air has been purged from the supply lines, burners should light within 4 seconds, After burner lights, rotate knob out of the LITE position. Try each burner in succession until all burners have been checlced.
quality of Flames
The combustion quality of burner flames needs to be determined visually.
(A) Yellow flames--Call for service
(t3) Yellow tips on outer
(C) Soft blue
tf burner flames look like (A), call for service_ Normal burner flames should look lilce (B) or (C), depending on the type of gas you use.
With LP gas, some yellow tipping on outer cones is
no rmal.
STEP 6
Check Ignition of Oven Burner
Your oven is designed to operate quietly and automatically. To operate the oven, turn the OVEN SET knob to a setting above 300°E (!49°C.)° After
To check ignition of the broil burner, turn the OVEN SET knob to BROIL. After
burner will ignite.
Hectric ignition models require electrical power to
operate. In case of a power outage, the oven burners on these models cannot be lit manually with a match.
Gas will not flow unless the glow bar is hot.
If the oven is in use when a power outage occurs, the oven burner will shut off and cannot be
power is restored.
STEP 7
Adjust Broil and Oven Burner Air
Adjustment Shutters if Necessary
Air adjustment shutters for the top and bottom
burners regulate the flow of air to the flames°
The air adjustment shutter for the top (broil) burner is in the center of the rear wall of the oven.
4O
