Sears 75571, 72671, 72675, 75471, 72678, 73271, 75376 Care and Cleaning, Burner Caps, Burner Heads

Care and Cleaning

Proper care and cleaning are important so your range will give you efficient and satisfactory service° Follow these directions carefully in caring for it to help assure safe and proper maintenance.

BE SURE ELECTRICAL POWER IS

DISCONNECTED BEFORE CLEANING

ANY PART OF YOUR RANGE.

Sealed Burner Assemblies

(on some models)

CAUTION: DO NOT OPERATE THE BURNER

WITHOUT ALL BURNER PARTS AND DRIP

PANS (IF SO EQUIPPED) IN PLACE.

	Grate
	Burner	cap
®	Drip pan (on some models)
	Burner	head

Electrode

Turn all controls off before removing burner parts and drip pans (ff so equipped).

The burner grates, caps, heads and drip pans (if so equipped) c_n be lifted off, making them easy to clean.

The	electrode		of
the	spark igniter			is	/// _Electrode
burner		head	is
removed.		When		one

burner is turned to LITE, all the burners spark. Do not attempt to disassemble or clean around

any burner while another burner is ono An electric shock may result, which could cause you to knock over hot cookwareo

Burner Heads

(on sealed burners only)

For proper ignition, make sure the small hole in the section that fits over the electrode is kept open. A

sewing needle or wire twist tie works well to unclog it.

The sets in the burner heads of your range must be

kept dean at all times for an even, unhampered flame. You should clean the surface burners routinely, especially after bad spiltovers, which could clog these openings_

To remove burned-on food, soak the burner heads in

a solution of mild liquid detergent and hot water for 20-30 minutes. For more stubborn stains, use a toothbrush.

Before putting the burner head back, shake out

excess water and then dry it thoroughly by setting it in a warm oven for 30 minutes°

Replace the burner caps. Make sure that caps are replaced on the correct size burner. There is one small, 2 medium and one large cap°

NOTE: On some models the caps are all the same size and can be used in any of the 4 needed locations.

Burner Caps

(on sealed burners only)

Lift offwhen cool. Wash burner caps in hot, soapy

water arid rinse with clean water° You may scour with a

plasdc scouring pad to remove burned-on food particles,

Dry them in a warm oven or with a cloth---don't reassemble them wet. Replace the burner ca 9so

Medium	_	_-Small	- Large
Medium
	Front of	ran e

Make sure that caps are replaced on the correct size burner_ There is one small, 2 medium and one large cap.

NOTE: On some models the caps are all the same size

27 and can be used in any of the 4 needed locations.

(continued nem page)