Sears 831.15403 - page 17

41. Wrap the Leg Lever Cable (70) under a 90mm
Pulley (39). Attach the Pulley and two HalfFinger
Guards (42) to the RightBase (1)with an M10 x
48mm Bolt(101) and an M10 Nylon Locknut
(114). Make surethe Finger Guards are orient-
ed as shown.
42. Wrap the Leg Lever Cable (70) over a 90mm
Pulley(39). Attachthe Pulley, aSmall Cable Trap
(48), and two Half Finger Guards (42) at the sec-
ond hole from the bottomof the two Pulley Plates
(51) withan M10 x 52mm Bolt (102) andan M10
NylonLocknut (114). Make sure the Cable Trap
and Finger Guards are oriented as shown.
43. Wrapthe Leg Lever Cable (70) under a 90mm
Pulley(39). Attach the Pulley andtwo Half Finger
Guards(42) tothe =U"-bracketon the RightBase
(1) with an MI0 x 48mm Bolt (101) and anM10
NylonLocknut (114). Make sure the Finger
Guards are oriented as shown and are on the
outside of the "U"-bracket.
44. Wrap the Leg Lever Cable (70) undera 90mm
Pulley(39). Attach the Pulley, a Small Cable Trap
(48), and two Half Finger Guards (42) to the
bracket on the RightBase (1) with an MI0 x
52mm Bolt (102) and an M10 Nylon Locknut
(114). Make sure the Cable Trap and Finger
Guards are oriented as shown and that the
bracket is between the Pulley andthe Finger
Guard next to the Locknut.
41 //
114
139 42
42
7O
45. Routethe LegLever Cable (70) up through the
RightTop Frame (7), over a115mm Pulley (41),
and backdown throughtheTop Frame.Attach
the Pulley inside the Top Frame withan M10 x
80mm Bolt (111), two M10 Washers (116), two
19mm Spacers (77), and an M10 Nylon Locknut
(114).
45
17