19.Attach the Leg Bumper (76) to the Right Seat Frame (9) with an M4 x 16mm
(113) and an M4 Washer (131).
Grease an M10 x 75mm Bolt (104). Attach the Leg Lever (11) to the Right Seat Frame (9) with
the Bolt and an M10 Nylon Locknut (114). Make sure the
the Leg Lever. Do not over tighten the
Locknut; the Leg Lever must be able to pivot easily.
20.Hold the Dip Assist (21) around the Rear Upright
(6) and Left Upright (5) as shown. Make sure the Dip Assist is under the indicated rod.
Attach the Cross Brace (64) to the Dip Assist (21) with an M10 x 232mm Bolt (108), two M10 Washers (116), and an M10 Nylon Locknut (114).
Grease an M10 x 232mm bolt (108). Attach the Dip Assist (21) to the Left Upright (5) with the Bolt and an M10 Nylon Locknut (114). Do not over- tighten the Locknut; the Dip Assist must be able to pivot easily.
Attach the Dip Assist Latch (67) to the Dip Assist
(21)with an M10 x 85mm Bolt (107), two M10 Washers (116), a 12mm Spacer (75), and an Mt0
Nylon Locknut (114). Do not overtighten the Locknut; the Dip Assist Latch must be able to pivot easily. Engage the Latch over the rod on the Rear Upright (6).
21.Wet the lower end of the Left ButterflyArm (18) with soapy water. Slide a Large Foam Pad (79) onto the ButterflyArm,
Note: an entire grease packet should be used for this step. Grease an M10 x 89ram Bolt (92) and the indicated edges of two Arm Bushings
(59).Attach the Left ButterflyArm (18) to the Butterfly Frame (22) with the Bolt, an M10 Large Washer (134), the two Arm Bushings, and an
M10 Nylon Locknut (114). Make sure the bolt
head fits inside the hole in the Butterfly Frame.
Repeat this step with the Right Butterfly Arm (17).
19
114
11
20
21
l
_ase__ 59r 79-_
12
