51.Route the Right Stack Cable (70) down through the Right Top Frame (7) and over a 90mm Pulley
(39).Attach the Pulley and a Small Cable Trap
(48)inside the Top Frame with an M10 x 80mm Bolt (111), two M10 Washers (116), a 19mm Spacer (77), a 16mm Spacer (124), and an M10
Nylon Locknut (114). Make sure the 16ram Spacer and the Small Cable Trap are on the same side of the Pulley.
52.Set an M12 Washer (129) on top of the Long Weight Tube (36). Thread an M12 Nut (128) all the way onto the Right Stack Cable (66).
Thread the Right Stack Cable (68) into the Long Weight Tube (36). "13ghtenthe M12 Nut (128) against the M12 Washer (129).
53.Locate the Press Cable (69). Grease an M8 x 86mm Shoulder Bolt (86). Attach the Cable to the Leg Press Frame (12) with the Bolt, an M8 Washer (117) and an M8 Nylon Locknut (115).
54.Wrap the Press Cable (69) around a 90mm Pulley (39). Attach the Pulley, two Half Finger Guards (42), a Small Cable Trap (48), and an
M10 Washer (116) to the Left Seat Frame (10) with an M10 x 103mm Bolt (106), an M10 Washer (116), and an M10 Nylon LocKnut(114). Make
sure the Cable Trap and Finger Guards are oriented as shown.
55.Wrap the Press Cable (69) around a
(40). Attach the
Press Frame (12) with an M10 x 118mm Bolt (100), an M10 Washer (116), and an M10 Nylon
Locknut (114). Make sure the Finger Guards are oriented as shown.
66
53
117
86
48
106.116
55
116 _j114
42
116
100
42
19
