Sharp AL-1035-WH, AL-1035-WH A COPY FUNCTIONS, NORMAL COPYING, Copying books or originals with folds or creases, 2 Close the document cover, [How to place the original]

2	Chapter 2
	COPY FUNCTIONS

This chapter explains how to use the copy functions.

NORMAL COPYING

This section explains how to make a regular copy.

1 Open the document cover and place the original.

Place the original face down on the document glass.

[How to place the original]

The corners of the original shall be aligned with the tip of the arrow mark ( ) on the scale mark of document glass.

A4 11x81/2

A5

81/2 x51/2

A6

ID

Mark

Document glass scale

Note	An original up to A4 can be placed on the
	document glass.

3 Set the number of copies with the [COPY COUNT] key ().

Up to 9 copies can be set.

A Single copy can be made even if "0" appears for the number of copies.

If you set the wrong number of copies, press Note the [CLEAR] key () and then enter the

correct number.

4 Press the [COPY START] key () to copy start.

The copy is delivered to the paper output tray.

• Remove the paper on the output tray Note whenever 10 sheets have been delivered.

•About 1 minutes after copying ends, the copy settings will restore to the initial settings.

•Press the [CLEAR] key ( ) to stop copying in the middle of a run.

Copying books or originals with folds or creases

Press down the document cover, while copies as shown. If the document cover is not completely closed, shadows may appear on the copy or it may be fuzzy. Flatten originals with folds or creases well before printing.

2 Close the document cover.

Be sure to close the document cover after placing the original. If left open, the areas outside the original will be copied black, causing excessive use of toner.

15