POWER ON AND OFF

The power switch is at the right side of the machine.

POWER ON

Turn the power switch to the "ON" position.

It takes about several

“ON” seconds for the machine to warm up. The machine can start copying only after warm-up. However, you can change settings and press the [COPY START] key () during warm-up. The copying will start immediately after warm-up.

POWER OFF

Be sure to turn the power switch to the "OFF" position when it is not being used.

“OFF”When the machine is

powered off during an

operation, misfeed may

occur, and the task being

processed will be cancelled.

Upon the startup of the machine, or when the [CLEAR] key ( ) is pressed twice, the machine will be restored Note to its initial settings. When the machine is restored to its initial settings, all the settings and selected functions

will be cancelled.

If no operation is performed in 3 minutes, the machine will automatically enter auto power shut off mode.

When the machine restores to the initial status after resolving the misfeed, do not turn off the power supply.

Auto power shut off

The auto power shut off mode helps to reduce the total power consumption and the running cost. It also helps to save natural resources and reduces environmental pollution.

If no operation is performed in 3 minutes when the machine is on, the machine will automatically enter auto power shut off mode (The 100% ratio indicator will flash, and all the other indicators will be off). To restore normal operation, press any key on the operation panel. The normal mode will be resumed when the machine receives any printing task.

Initial setting

Upon the startup of the machine, or when the [CLEAR] key ( )is pressed twice, or when it has been left untouched for 1 minute after finishing a task, the machine will be restored to its initial settings.

Copy ratio: 100%, Exposure:3Copy count: 0, All special copier modes: OFF

6