SCANNING FROM THE MACHINE

(SCAN to USB)

Send the scanned image to the USB memory connected to the machine according to the following steps. The relevant file is saved in the USB memory.

Scanning from the operation panel of the machine

1 Connect the USB memory to the USB interface (A type) of the machine.2 Place the original that you wish to scan on the document glass.

For placement of the original, please refer to "NORMAL COPYING" (Page15).

3 Select scan settings by pressing the keys on the operation panel.

The scanning ratio is 100%.

You can also select ID MODE.

Press the [DENSITY] key () to adjust the exposure level as needed. If exposure level 2 or 4 is selected, the two indicators of 1, 3 or 3, 5 will light simultaneously.

4 Press the [SCAN to USB ] key ( ) to start scanning .

Note

•

When scanning an ID card (ID card mode),

 

the LED indicator and ID Copy indicator will

 

 

flash after one side of the ID card has been

 

 

scanned. Turn over the ID card on the

 

 

document glass within 30 seconds and

 

 

press the [ SCAN to USB ] key (

)

 

 

again to finish scanning.

 

•To stop scanning, press the [CLEAR] key ().

•To return to the default state, press the [CLEAR] key () twice.

•For restrictions on COPY/PRINT in the SCAN mode or the restrictions on SCAN in the COPY or PRINT mode, please refer to

"OPERATION IN COPY, PRINT AND SCAN MODE" (Page10).

•The storage folder for normal scanning is different from that of ID card scanning. (Please use your USB memory stick icon to replace the "H" in the following paths.) Normal scanning: H:\documents\Photo ID card scanning: H:\documents\ID card

•Do not unplug the USB memory when the USB indicator is flashing.

29