Sharp DK227N operation manual Setting the clock Remote Control only, To confirm the time display

Setting the clock (Remote Control only)

XL-DK227N

In this example, the clock is set for the 12-hour (AM 12:00) display.

1Press the ON/STAND-BY button to turn the power on.

2Press the CLOCK/TIMER button.

3Within 10 seconds, press the or button to select “CLOCK”, and press the MEMORY button.

4Press the or button to select 12-hour or 24- hour display and then press the MEMORY button.

5Press the or button to adjust the hour and then press the MEMORY button.

Press the or button once to advance the time by

1hour. Hold it down to advance continuously.

6Press the or button to adjust the minutes and then press the MEMORY button.

Press the or button once to advance the time by

1minute. Hold it down to change the time in 5-minute intervals.

To confirm the time display:

[When the unit is in the stand-by mode] Press the CLOCK/TIMER button.

The time display will appear for about 10 seconds.

[When the power is on]

Press the CLOCK/TIMER button.

Within 10 seconds, press the or button to display the time.

The time display will appear for about 10 seconds.

Note:

The “CLOCK” will appear or time will flash to confirm the time display when the AC power supply is restored after a power failure or unplugging the unit. If incorrect, readjust the clock as follows.

Basic Operation

“AM 12:00”

“AM 0:00”

“0:00”

The 12-hour display will appear. (AM 12:00 - PM 11:59)

The 12-hour display will appear. (AM 0:00 - PM 11:59)

The 24-hour display will appear. (0:00 - 23:59)

To readjust the clock:

Perform “Setting the clock” from step 1. If the “CLOCK” does not appear in step 3, step 4 (for selecting the 12-hour or 24-hour display) will be skipped.

To change the 12-hour or 24-hour display:

1Clear all the programmed contents. [Refer to “Factory reset, clearing all memory” on page 34 for details.]

2Perform “Setting the clock” from step 1 onwards.

15