Sharp DK227N Troubleshooting chart, References, CD player, Tuner, General, Remote control, iPod

Models: DK227N

1 36
Download 36 pages 21.8 Kb
Page 33
Image 33
Troubleshooting chart

Troubleshooting chart

XL-DK227N

Many potential problems can be resolved by the owner without calling a service technician.

If something is wrong with this product, check the following before calling your authorized SHARP dealer or service center.

General

Symptom

Possible cause

 

 

The clock is not set to the

Did a power failure occur? Reset

correct time.

the clock. (Refer page 15)

 

 

When a button is pressed,

Set the unit to the power stand-

the unit does not respond.

by mode and then turn it back on.

 

If the unit still malfunctions, reset

 

it. (Refer page 34)

 

 

No sound is heard.

Is the volume level set to “0”?

 

Are the headphones connected?

 

Are the speaker wires

 

disconnected?

 

 

CD player

Symptom

Possible cause

 

 

Playback does not start.

Is the disc loaded upside down?

Playback stops in the

Does the disc satisfy the

middle or is not performed

standards?

properly.

Is the disc distorted or

 

 

scratched?

 

 

Playback sounds are

Is the unit located near excessive

skipped, or stopped in the

vibrations?

middle of a track.

Is the disc very dirty?

 

 

Has condensation formed inside

 

the unit?

 

 

Remote control

Symptom

Possible cause

 

 

The remote control does

Is the AC power cord of the unit

not operate.

plugged in?

 

Is the battery polarity correct?

 

Are the batteries dead?

 

Is the distance or angle

 

incorrect?

 

Does the remote control sensor

 

receive strong light?

Tuner

Symptom

Possible cause

 

 

The radio makes unusual

Is the unit placed near the TV or

noises continuously.

computer?

 

Is the FM antenna or AM loop

 

antenna placed properly? Move

 

the antenna away from the AC

 

power cord if it's located nearby.

iPod

Symptom

Possible cause

 

 

No sound is produced.

The iPod is not playing.

No image appears on the

The iPod is not properly

TV/monitor.

connected to the unit.

 

Is the AC power cord of the unit

 

plugged in?

 

The video cable is not properly

 

connected.

 

The TV/monitor’s input selection

 

is not properly set.

 

Does the display shows “DOCK

 

OK”.

 

 

iPod will not charge.

Wrong iPod adaptor is used.

 

The iPod is not making full

 

contact with the iPod connector.

 

The main unit is in stand-by

 

mode.

 

Using 3rd Generation iPod

 

 

References

33

Page 33
Image 33
Sharp DK227N operation manual Troubleshooting chart, References, CD player, Tuner, General, Remote control, iPod