Sharp LC-32LE340E operation manual Remote Control Handset, Switching On/Off

Remote Control Handset

Inserting Batteries

•Remove the battery cover located on the back of the handset by gently pulling backwards from the indicated part.

•Insert two AAA/R3 or equivalent type batteries inside. Observe the correct polarity (+/-) when inserting batteries and replace the battery cover.

Note: Remove the battery from remote control handset when it is not to be used for a long period. Otherwise it can be damaged due to any leakage of batteries. Remote range is approximately 7m/23ft.

Switching On/Off

To Switch the TV On

•Connect the power cord to the 220-240V AC, 50 Hz socket.

•Switch the “” button on the rear left hand side to position “” so the TV will switch to standby mode. Then the standby LED lights up.

•To switch on the TV from standby mode either:

•Press the “” button, P+ / P- or a numeric button on the remote control.

•Press the -P/CHor P/CH+ touch button on the TV. The TV will then switch on.

Note: If you switch on your TV via standby button on the remote control, the programme/source that you were watching last will be reselected. The TV will switch on with the last selected channel number, regardless of the channel number that you select from the remote control to switch on the TV.

By either method the TV will switch on.

To Switch the TV Off

•Switch the “” button to position 2 as illustrated,

so the TV will switch OFF.

•To power down the TV completely, unplug the power cord from the mains socket.

English

Note: When the TV is switched to standby mode, standby LED can blink to indicate that features such as Standby Search, Over Air Download or Timer is active. The LED can also blink when you switch on the TV from standby mode.

Standby Notifications

If the TV switches off while in No Signal mode, the following on-screen message will be displayed on the next switch-on:

When the Auto Tv Off timeout is reached, the following message will be displayed on the screen. Select YES to shut down the TV. Select NO to cancel. The TV will switch off as well, if you do not make a selection on this screen.

If the TV switches off owing to the auto power down feature, the following on-screen message will be displayed on the next switch-on:

Digital Teletext (*)

•Press the “” button.

•The digital teletext information appears.

•Operate it with the coloured buttons, cursor buttons and OK button.

The operation method may differ depending on the contents of the digital teletext.

Follow the instructions displayed on digital teletext screen.

•When Press “OK” button or similar message appears on the screen, press the OK button.

•When the “” button is pressed, the TV returns to television broadcasting.

-18 -

A01_[GB]_MB70_5112UK_DVBT_C_DLNA_HBBTV_MMH_WIFI_32942LED _GOLD11_10075886_50201414.indd 18 16.04.2012 14:49:58