Sharp R-959M Building-In-Kit, Electrical Connection, Warning This Appliance Must Be Earthed

R-959M[1-34].qxd 29/8/06 1:48 PM Page 5

INSTALLATION

position is strong enough to take the oven weight, plus the heaviest item likely to be cooked in the oven.

3. The minimum
height of free space	13cm
necessary above
the top surface of
the oven is 13cm.

4.Do not place the oven where heat, moisture or high humidity are generated, (for example, near or above a conventional oven) or near combustible materials (for example, curtains). Do not block or obstruct air vent openings. Do not place objects on top of the oven.

5.Make sure the power supply cord is undamaged (See “ELECTRICAL CONNECTION” below).

Do not allow the power supply cord to run over any hot or sharp surfaces, such as the hot air vent area at the top rear of the oven.

6.The socket must be readily accessible so that it can be easily unplugged in an emergency.

7.Do not use the oven outdoors.

BUILDING-IN-KIT.

An installation frame is available which enables the microwave oven to be integrated within a kitchen unit.

The microwave oven is not designed to be built above or near a conventional oven.

SHARP recommend the use of the build in kit EBR-9910(for R-959M) or EBR-99ST(for R- 98STM-A), available from your SHARP dealer. Only the use of this frame will guarantee the quality and safety of the oven.

ELECTRICAL CONNECTION.

•Do not allow water to come into contact with the power supply cord or plug.

•Insert the plug properly into the socket.

•Do not connect other appliances to the same socket using an adaptor plug.

•If the power supply cord is damaged, it must be replaced by a Sharp approved service facility or a similarly qualified person to avoid a hazard.

•When removing the plug from the socket always grip the plug, never the cord as this may damage the power supply cord and the connections inside the plug.

•If the plug fitted to your oven is a rewireable type and in the event of the socket outlet in your home not being compatible with the plug supplied, remove the plug properly (do not cut off).

•If the plug fitted to your oven is a non- rewirable type and in the event of the socket outlet in your home not being compatible with the plug supplied, cut-off the mains plug.

•Refit with a suitable type, observing the wiring code given in ‘To replace the mains plug’ on page 36.

WARNING: THIS APPLIANCE

MUST BE EARTHED

To wire an appropriate plug, follow the wiring code given in `To replace the mains plug’ on page 36.

IMPORTANT!

•The fuse from the cut-off plug should be removed and the plug disposed of in a safe manner.

•Under no circumstances should the cut-off plug be inserted into a socket outlet as a serious electric shock may occur.

•The plug must not be used without the fuse cover fitted.

•If you have any doubt about your microwave oven obtain the help of a qualified electrician.

•When replacing the plug please ensure that you use a BSI or ASTA approved plug to BS1363, this should be fitted with a brown coloured 13 amp fuse approved by BSI or ASTA to BS1362. If you have any doubt about electrical connection seek the help of a qualified electrician.

5