Preparation
Removing the stand
Before detaching (or attaching) stand, unplug the AC cord from the AC input and the system cable from the Display.
CAUTION
•Do not remove the stand from the Display unless using an optional wall mount bracket to mount it.
Before attaching/detaching stand
•Before performing work make sure to turn off the System.
•Before performing work spread cushioning over the base area to lay the Display on. This will prevent it from being damaged.
1
2
Unfasten the four screws used to secure the stand in place.
Detach the stand from the Display.
(Hold the stand so it will not drop from the edge of the base area.)
CAUTION
• Do not remove the stand and speaker from the Display unless using an optional bracket to mount it.
NOTE
• To attach the stand, perform the above steps in reverse order.
Setting the Display on the wall
CAUTION
•Installing the Liquid Crystal Television requires special skill that should only be performed by qualified service personnel. Customers should not attempt to do the work themselves. SHARP bears no responsibility for improper mounting or mounting that results in accident or injury.
Using an optional bracket to mount the Display
•You can ask a qualified service personnel about using an optional
•Carefully read the instructions that come with the bracket before beginning work.
Hanging on the wall
Vertical mounting | Angular mounting |
About setting the Display angle LC-37G2X
•You can set the Display on the wall up to 5 degrees forward when the speakers are attached and up to 20 degrees forward when the speakers are not attached. Do not set the angle outside those ranges.
LC-32G2X
•You can set the Display on the wall up to 15 degrees forward when the speakers are attached and up to 20 degrees forward when the speakers are not attached. Do not set the angle outside those ranges.
13
