1 Stick each spacer to the stand as shown.
Peel each spacer away from the paper and attach to the four bulging areas
on the stand.Stand spacer
Bulge
Bulge
4 Attach the stand using the stand screws as shown.
Stand screw
Preparation
Setting the AVC System with the stand
How to install the AVC System vertically using the stand unit.
• Use the supplied stand unit for installing the AVC System vertically in an upright position.
2 Attach each cushion to the stand as shown.
Peel each cushion |
|
away from the |
|
paper and attach | Stand cushion |
to the four areas | |
at the bottom. |
|
| Attaching point |
3 Fit the stand to the AVC System.
Insert the stand into the |
|
AVC System, making |
|
sure that the bulges of |
|
the stand align with the | Bulge |
holes on the AVC |
|
System. |
|
Attaching point
Hole
The AVC System installed vertically with the stand.
NOTE
•When mounting the AVC System vertically, always use the supplied stand. Be careful not to block vent holes when standing up directly on the floor or a flat surface as this can result in equipment failure.
Bottom view
The name plate is attached on the bottom of the AVC System. Confirm it if necessary.
11
