Power ON/OFF
Projector | Remote control | Press POWER ON. |
|
| • The blinking green LAMP REPLACEMENT indicator |
|
| shows that the lamp is warming up. Wait until the |
| POWER | indicator stops blinking before operating the projector. |
| • If the power is turned off and then immediately turned | |
|
| on again, it may take a short while before the lamp |
|
| turns on. |
|
| • After the projector is unpacked and turned on for the first |
|
| time, a slight odor may be emitted from the exhaust vent. |
|
| This odor will soon disappear with use. |
|
| When the power is on, the LAMP REPLACEMENT |
|
| indicator lights, indicating the status of the lamp. |
|
| Green: Lamp is ready. |
|
| Green blinking: Warming up. |
|
| Red: Change the lamp. |
LAMP REPLACEMENT indicator
Setup & Connections
|
|
| Press POWER OFF. | |
|
|
| Press POWER OFF again while the message is | |
|
|
| displayed to turn off the power. | |
|
|
| • If you accidentally pressed POWER OFF and do not want | |
|
|
|
| to turn off the power, wait until the power off screen |
|
|
|
| disappears. |
|
|
| • When the power is turned off, the POWER indicator will light | |
|
|
|
| up red and the cooling fan will run for about 90 seconds. |
|
|
|
| The projector will then enter standby mode. |
|
|
| • Wait until the cooling fan stops before disconnecting the | |
|
|
|
| power cord. |
|
|
| • The power can be turned on again by pressing POWER | |
|
|
|
| ON. When the power is turned on, the POWER indicator |
|
|
|
| and the LAMP REPLACEMENT indicator light green. |
|
|
| • The POWER indicator flashes if the bottom filter cover is | |
|
|
|
| not securely installed. |
|
|
|
|
|
|
|
|
| WARNING: |
|
|
|
| The cooling fan in this projector continues to run for |
|
|
|
| about 90 seconds after the projector is turned off. |
|
|
|
| During normal operation, when turning the power off |
|
|
|
| always use the POWER OFF button on the projector or |
|
|
|
| on the remote control. Ensure the cooling fan has |
|
|
|
| stopped before disconnecting the power cord. |
|
|
|
| DURING NORMAL OPERATION, NEVER TURN THE |
|
|
|
| PROJECTOR OFF BY DISCONNECTING THE POWER |
|
|
|
| CORD. FAILURE TO OBSERVE THIS WILL RESULT IN |
|
|
|
| PREMATURE LAMP FAILURE. |
|
|
|
|
|
22 | 02.3.19, 7:04 PM |
