Analog Modules
5-127
S7-400, M7-400 Programmable Controllers Module Specifications
A5E00069467-07
Table 5-71 Parameters of the SM 431; AI 8 RTD 16 Bit, continued
Parameter ScopeParameter
Type
Default2)
Value Range
Interference
suppression 60 Hz; 50 Hz; none 60 Hz
Smoothing None
Low
Average
High
None
Static Channel
1) If you use the module in ER-1/ER-2, you must set this parameter to “No” because the interrupt lines are
not available in ER-1/ER-2.
2) Only in the CC (central controller) is it possible to start up the analog modules with the default settings.
3) The limit values must be within the temperature range of the connected sensor.
Smoothing of the Measured Values
You fill find information that is generally applicable to the smoothing of analogvalues in Section 5.6.The following figure shows for the module the number of module cycles, in thecase of a step response, after which the smoothed analog value is applied toalmost 100%, depending on the smoothing setting. The figure applies to everychange of signal at an analog input.
50
100
0
63
Smoothing: low:
average:
high: Module cycles
Signal variation
in percent Step response for any analog input signal
60 8020 10040
Figure 5-40 Step Response of the SM 431; AI 8 RTD 16 Bit