Siemens manual Operating in Local Mode, Operating in Master Mode Individual Control of SED2 VFD

SED2 AOP Operating Instructions

2.Press to confirm the selected operating mode (press to return to the main menu.)

NOTE: To exit an operating mode, either follow the on-screen instructions or return to the main menu and select the mode menu to choose a different operating mode.

Operating in Local Mode

On initial power-up or after a reset, the AOP defaults to the Local operating mode. The Local mode operates only with one SED2. You can change the operating mode via the mode menu. You can control the SED2 VFD by accessing all normal SED2 and AOP internal parameters.

Operating in Master Mode

(Individual Control of SED2 VFD)

In Master mode, the AOP can control up to 31 SED2 drives that connect in a multi-drop network arrangement. Full operator control of each SED2 is possible with access to all normal SED2 parameters.

Control of the SED2 drives can be individually or by broadcast method.

1.In master mode, selecting Operate from the main menu displays an operation screen.

2.Use and to select a slave SED2 VFD. A two-digit number on the left-hand side of the screen identifies each SED2 VFD. In the top, left-hand corner of the screen, an icon indicates the current operating status of the highlighted SED2 VFD. The following table describes the icons.

NOTE: To configure SED2 VFDs for network operation, set Command Source P0700[1]=5 (USS on Com link), set USS Telegram Off Time for Serial Interface Com Link P2014[0]=5000, and USS Address for Serial Interface Com Link P2011[0]=a unique number for each drive on the network.

Icon

Description

F

A

U

Indicates the SED2 VFD is active and communicating.

Indicates no active slave (icon is blank).

Indicates a SED2 VFD fault has been recorded and the SED2 VFD has tripped.

Indicates a SED2 VFD with active warnings.

Indicates a SED2 VFD with communications problems.

Indicates a non-SED2 VFD - parameter upload only.

20 Siemens Building Technologies